.. raw:: latex \clearpage .. _dpdk_test_environment: .. include:: ../introduction/test_environment_intro.rst .. include:: ../introduction/test_environment_sut_conf_1.rst DUT Settings - DPDK ------------------- DPDK Version ~~~~~~~~~~~~ |dpdk-release| DPDK Compile Parameters ~~~~~~~~~~~~~~~~~~~~~~~ .. code-block:: bash make install T=--linuxapp-gcc -j Testpmd Startup Configuration ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Testpmd startup configuration changes per test case with different settings for `$$INT`, `$$CORES`, `$$RXQ`, `$$RXD` and max-pkt-len parameter if test is sending jumbo frames. Startup command template: .. code-block:: bash testpmd -v -l $$CORE_LIST -w $$INT1 -w $$INT2 --master-lcore 0 --in-memory -- --forward-mode=io --burst=64 --txd=$$TXD --rxd=$$RXD --txq=$$TXQ --rxq=$$RXQ --tx-offloads=0x0 --numa --auto-start --total-num-mbufs=16384 --nb-ports=2 --portmask=0x3 --disable-link-check --max-pkt-len=$$PKT_LEN [--mbuf-size=16384] --nb-cores=$$CORES L3FWD Startup Configuration ~~~~~~~~~~~~~~~~~~~~~~~~~~~ L3FWD startup configuration changes per test case with different settings for `$$INT`, `$$CORES` and enable-jumbo parameter if test is sending jumbo frames. Startup command template: .. code-block:: bash l3fwd -v -l $$CORE_LIST -w $$INT1 -w $$INT2 --master-lcore 0 --in-memory -- --parse-ptype --eth-dest="0,${adj_mac0}" --eth-dest="1,${adj_mac1}" --config="${port_config}" [--enable-jumbo] -P -L -p 0x3 .. include:: ../introduction/test_environment_tg.rst .. include:: ../introduction/test_environment_pre_test_server_calib.rst .. include:: ../introduction/test_environment_sut_calib_skx.rst .. include:: ../introduction/test_environment_sut_calib_clx.rst .. include:: ../introduction/test_environment_sut_calib_hsw.rst .. include:: ../introduction/test_environment_sut_calib_dnv.rst .. include:: ../introduction/test_environment_sut_calib_tsh.rst .. include:: ../introduction/test_environment_sut_calib_tx2.rst