3n-tsh-x520

10ge2p1x520-dot1q-ip6base-ndrpdr

RFC2544: Pkt throughput IPv6 routing with IEEE 802.1Q test cases

  • [Top] Network Topologies: TG-DUT1-DUT2-TG 3-node circular topology with single links between nodes.

  • [Enc] Packet Encapsulations: Eth-IPv6 for IPv6 routing. IEEE 802.1Q tagging is applied on link between DUT1 and DUT2.

  • [Cfg] DUT configuration: DUT1 and DUT2 are configured with IPv6 routing and two static IPv6 /64 route entries. DUT1 and DUT2 are tested with Intel-X520-DA2.

  • [Ver] TG verification: TG finds and reports throughput NDR (Non Drop Rate) with zero packet loss tolerance and throughput PDR (Partial Drop Rate) with non-zero packet loss tolerance (LT) expressed in percentage of packets transmitted. NDR and PDR are discovered for different Ethernet L2 frame sizes using MLRsearch library. Test packets are generated by TG on links to DUTs. TG traffic profile contains two L3 flow-groups (flow-group per direction, 253 flows per flow-group) with all packets containing Ethernet header, IPv6 header with IP protocol=61 and static payload. MAC addresses are matching MAC addresses of the TG node interfaces.

  • [Ref] Applicable standard specifications: RFC2544.

 Test Name 

 Throughput: 
1. Mpps Gbps (NDR)
2. Mpps Gbps (PDR)

One-Way Latency Percentiles in uSec at %PDR load,
one set per each direction:
3. P50 P90 P99 P50 P90 P99 (10% PDR)
4. P50 P90 P99 P50 P90 P99 (50% PDR)
5. P50 P90 P99 P50 P90 P99 (90% PDR)

 78b-1t1c-dot1q-ip6base-ndrpdr 

 1.  4.15       3.25 
2. 4.27 3.35

3. 23 61 107 23 46 111
4. 78 108 118 38 118 124
5. 101 136 157 110 144 181

 78b-2t2c-dot1q-ip6base-ndrpdr 

 1.  6.12       4.79 
2. 6.18 4.84

3. 23 71 87 23 67 77
4. 57 90 107 53 91 108
5. 103 129 154 103 129 148

 78b-4t4c-dot1q-ip6base-ndrpdr 

 1.  7.70       6.04 
2. 7.70 6.04

3. 23 41 61 23 26 50
4. 24 51 63 24 33 51
5. 66 86 100 66 84 98

10ge2p1x520-ethip6-ip6base-ndrpdr

RFC2544: Pkt throughput IPv6 routing test cases

  • [Top] Network Topologies: TG-DUT1-DUT2-TG 3-node circular topology with single links between nodes.

  • [Enc] Packet Encapsulations: Eth-IPv6 for IPv6 routing.

  • [Cfg] DUT configuration: DUT1 and DUT2 are configured with IPv6 routing and two static IPv6 /64 route entries. DUT1 and DUT2 tested with Intel-X520-DA2.

  • [Ver] TG verification: TG finds and reports throughput NDR (Non Drop Rate) with zero packet loss tolerance and throughput PDR (Partial Drop Rate) with non-zero packet loss tolerance (LT) expressed in percentage of packets transmitted. NDR and PDR are discovered for different Ethernet L2 frame sizes using MLRsearch library. Test packets are generated by TG on links to DUTs. TG traffic profile contains two L3 flow-groups (flow-group per direction, 253 flows per flow-group) with all packets containing Ethernet header, IPv6 header and static payload. MAC addresses are matching MAC addresses of the TG node interfaces.

  • [Ref] Applicable standard specifications: RFC2544.

 Test Name 

 Throughput: 
1. Mpps Gbps (NDR)
2. Mpps Gbps (PDR)

One-Way Latency Percentiles in uSec at %PDR load,
one set per each direction:
3. P50 P90 P99 P50 P90 P99 (10% PDR)
4. P50 P90 P99 P50 P90 P99 (50% PDR)
5. P50 P90 P99 P50 P90 P99 (90% PDR)

 78b-1t1c-ethip6-ip6base-ndrpdr 

 1.  4.60       3.60 
2. 4.62 3.62

3. 23 92 111 23 39 97
4. 49 106 115 50 116 124
5. 119 140 197 121 146 201

 78b-2t2c-ethip6-ip6base-ndrpdr 

 1.  6.29       4.93 
2. 6.43 5.04

3. 23 39 54 23 36 55
4. 49 94 110 46 102 112
5. 96 119 148 97 120 150

 78b-4t4c-ethip6-ip6base-ndrpdr 

 1.  7.75       6.07 
2. 7.75 6.07

3. 23 41 59 23 29 58
4. 24 50 62 24 30 38
5. 65 82 95 65 84 97

10ge2p1x520-ethip6-ip6scale200k-ndrpdr

RFC2544: Pkt throughput IPv6 routing test cases

  • [Top] Network Topologies: TG-DUT1-DUT2-TG 3-node circular topology with single links between nodes.

  • [Enc] Packet Encapsulations: Eth-IPv6 for IPv6 routing.

  • [Cfg] DUT configuration: DUT1 and DUT2 are configured with IPv6 routing and 2x100k static IPv6 /64 route entries. DUT1 and DUT2 tested with Intel-X520-DA2.

  • [Ver] TG verification: TG finds and reports throughput NDR (Non Drop Rate) with zero packet loss tolerance and throughput PDR (Partial Drop Rate) with non-zero packet loss tolerance (LT) expressed in percentage of packets transmitted. NDR and PDR are discovered for different Ethernet L2 frame sizes using MLRsearch library. Test packets are generated by TG on links to DUTs. TG traffic profile contains two L3 flow-groups (flow-group per direction, 100k flows per flow-group) with all packets containing Ethernet header, IPv6 header with IP and static payload. MAC addresses are matching MAC addresses of the TG node interfaces. Incrementing of IP.dst (IPv6 destination address) field is applied to both streams.

  • [Ref] Applicable standard specifications: RFC2544.

 Test Name 

 Throughput: 
1. Mpps Gbps (NDR)
2. Mpps Gbps (PDR)

One-Way Latency Percentiles in uSec at %PDR load,
one set per each direction:
3. P50 P90 P99 P50 P90 P99 (10% PDR)
4. P50 P90 P99 P50 P90 P99 (50% PDR)
5. P50 P90 P99 P50 P90 P99 (90% PDR)

 78b-1t1c- 
ethip6-ip6scale200k-ndrpdr

 1.  2.25       1.76 
2. 2.26 1.77

3. 23 71 111 23 65 113
4. 31 173 191 32 176 194
5. 178 222 267 129 188 225

 78b-2t2c- 
ethip6-ip6scale200k-ndrpdr

 1.  3.75       2.94 
2. 3.75 2.94

3. 23 66 132 24 63 136
4. 76 176 199 87 185 207
5. 143 193 222 141 197 225

 78b-4t4c- 
ethip6-ip6scale200k-ndrpdr

 1.  6.02       4.72 
2. 6.05 4.74

3. 24 88 103 24 81 100
4. 61 94 113 52 94 105
5. 110 133 148 101 132 148

10ge2p1x520-ethip6-ip6scale20k-ndrpdr

RFC2544: Pkt throughput IPv6 routing test cases

  • [Top] Network Topologies: TG-DUT1-DUT2-TG 3-node circular topology with single links between nodes.

  • [Enc] Packet Encapsulations: Eth-IPv6 for IPv6 routing.

  • [Cfg] DUT configuration: DUT1 and DUT2 are configured with IPv6 routing and 2x10k static IPv6 /64 route entries. DUT1 and DUT2 tested with Intel-X520-DA2.

  • [Ver] TG verification: TG finds and reports throughput NDR (Non Drop Rate) with zero packet loss tolerance and throughput PDR (Partial Drop Rate) with non-zero packet loss tolerance (LT) expressed in percentage of packets transmitted. NDR and PDR are discovered for different Ethernet L2 frame sizes using MLRsearch library. Test packets are generated by TG on links to DUTs. TG traffic profile contains two L3 flow-groups (flow-group per direction, 10k flows per flow-group) with all packets containing Ethernet header, IPv6 header with IP and static payload. MAC addresses are matching MAC addresses of the TG node interfaces. Incrementing of IP.dst (IPv6 destination address) field is applied to both streams.

  • [Ref] Applicable standard specifications: RFC2544.

 Test Name 

 Throughput: 
1. Mpps Gbps (NDR)
2. Mpps Gbps (PDR)

One-Way Latency Percentiles in uSec at %PDR load,
one set per each direction:
3. P50 P90 P99 P50 P90 P99 (10% PDR)
4. P50 P90 P99 P50 P90 P99 (50% PDR)
5. P50 P90 P99 P50 P90 P99 (90% PDR)

 78b-1t1c- 
ethip6-ip6scale20k-ndrpdr

 1.  2.99       2.34 
2. 3.35 2.63

3. 23 68 103 23 60 107
4. 35 123 139 36 118 144
5. 100 129 147 95 137 156

 78b-2t2c- 
ethip6-ip6scale20k-ndrpdr

 1.  5.00       3.92 
2. 5.17 4.06

3. 23 72 130 23 90 124
4. 57 115 139 53 121 138
5. 127 159 213 126 161 196

 78b-4t4c- 
ethip6-ip6scale20k-ndrpdr

 1.  6.94       5.44 
2. 7.11 5.58

3. 23 64 82 24 64 80
4. 47 82 93 37 81 93
5. 84 109 119 85 104 116

10ge2p1x520-ethip6-ip6scale2m-ndrpdr

RFC2544: Pkt throughput IPv6 routing test cases

  • [Top] Network Topologies: TG-DUT1-DUT2-TG 3-node circular topology with single links between nodes.

  • [Enc] Packet Encapsulations: Eth-IPv6 for IPv6 routing.

  • [Cfg] DUT configuration: DUT1 and DUT2 are configured with IPv6 routing and 2x1M static IPv6 /64 route entries. DUT1 and DUT2 tested with Intel-X520-DA2.

  • [Ver] TG verification: TG finds and reports throughput NDR (Non Drop Rate) with zero packet loss tolerance and throughput PDR (Partial Drop Rate) with non-zero packet loss tolerance (LT) expressed in percentage of packets transmitted. NDR and PDR are discovered for different Ethernet L2 frame sizes using MLRsearch library. Test packets are generated by TG on links to DUTs. TG traffic profile contains two L3 flow-groups (flow-group per direction, 1M flows per flow-group) with all packets containing Ethernet header, IPv6 header with IP and static payload. MAC addresses are matching MAC addresses of the TG node interfaces. Incrementing of IP.dst (IPv6 destination address) field is applied to both streams.

  • [Ref] Applicable standard specifications: RFC2544.

 Test Name 

 Throughput: 
1. Mpps Gbps (NDR)
2. Mpps Gbps (PDR)

One-Way Latency Percentiles in uSec at %PDR load,
one set per each direction:
3. P50 P90 P99 P50 P90 P99 (10% PDR)
4. P50 P90 P99 P50 P90 P99 (50% PDR)
5. P50 P90 P99 P50 P90 P99 (90% PDR)

 78b-1t1c- 
ethip6-ip6scale2m-ndrpdr

 1.  1.90       1.49 
2. 2.09 1.64

3. 23 67 103 24 62 106
4. 57 221 256 64 233 265
5. 134 210 242 143 221 255

 78b-2t2c- 
ethip6-ip6scale2m-ndrpdr

 1.  3.60       2.82 
2. 3.67 2.88

3. 23 81 152 24 59 139
4. 89 188 217 104 183 222
5. 154 221 295 164 226 282

 78b-4t4c- 
ethip6-ip6scale2m-ndrpdr

 1.  5.76       4.52 
2. 6.11 4.79

3. 24 73 92 24 73 91
4. 72 112 132 75 113 140
5. 111 140 162 114 142 164