3n-tsh-x520

10ge2p1x520-dot1q-ip6base-ndrpdr

RFC2544: Pkt throughput IPv6 routing with IEEE 802.1Q test cases

  • [Top] Network Topologies: TG-DUT1-DUT2-TG 3-node circular topology with single links between nodes.

  • [Enc] Packet Encapsulations: Eth-IPv6 for IPv6 routing. IEEE 802.1Q tagging is applied on link between DUT1 and DUT2.

  • [Cfg] DUT configuration: DUT1 and DUT2 are configured with IPv6 routing and two static IPv6 /64 route entries. DUT1 and DUT2 are tested with Intel-X520-DA2.

  • [Ver] TG verification: TG finds and reports throughput NDR (Non Drop Rate) with zero packet loss tolerance and throughput PDR (Partial Drop Rate) with non-zero packet loss tolerance (LT) expressed in percentage of packets transmitted. NDR and PDR are discovered for different Ethernet L2 frame sizes using MLRsearch library. Test packets are generated by TG on links to DUTs. TG traffic profile contains two L3 flow-groups (flow-group per direction, 253 flows per flow-group) with all packets containing Ethernet header, IPv6 header with IP protocol=61 and static payload. MAC addresses are matching MAC addresses of the TG node interfaces.

  • [Ref] Applicable standard specifications: RFC2544.

 Test Name 

 Throughput: 
1. Mpps Gbps (NDR)
2. Mpps Gbps (PDR)

One-Way Latency Percentiles in uSec at %PDR load,
one set per each direction:
3. P50 P90 P99 P50 P90 P99 (10% PDR)
4. P50 P90 P99 P50 P90 P99 (50% PDR)
5. P50 P90 P99 P50 P90 P99 (90% PDR)

 78b-1t1c-dot1q-ip6base-ndrpdr 

 1.  4.21       3.30 
2. 4.36 3.42

3. 23 59 74 23 59 76
4. 48 74 80 52 77 91
5. 124 155 183 129 167 204

 78b-2t2c-dot1q-ip6base-ndrpdr 

 1.  6.01       4.71 
2. 6.26 4.91

3. 23 51 68 23 51 60
4. 51 91 105 53 93 105
5. 104 128 153 107 132 157

 78b-4t4c-dot1q-ip6base-ndrpdr 

 1.  7.67       6.01 
2. 7.67 6.01

3. 23 40 60 23 26 47
4. 24 49 62 24 35 53
5. 63 87 99 66 85 99

10ge2p1x520-ethip6-ip6base-ndrpdr

RFC2544: Pkt throughput IPv6 routing test cases

  • [Top] Network Topologies: TG-DUT1-DUT2-TG 3-node circular topology with single links between nodes.

  • [Enc] Packet Encapsulations: Eth-IPv6 for IPv6 routing.

  • [Cfg] DUT configuration: DUT1 and DUT2 are configured with IPv6 routing and two static IPv6 /64 route entries. DUT1 and DUT2 tested with Intel-X520-DA2.

  • [Ver] TG verification: TG finds and reports throughput NDR (Non Drop Rate) with zero packet loss tolerance and throughput PDR (Partial Drop Rate) with non-zero packet loss tolerance (LT) expressed in percentage of packets transmitted. NDR and PDR are discovered for different Ethernet L2 frame sizes using MLRsearch library. Test packets are generated by TG on links to DUTs. TG traffic profile contains two L3 flow-groups (flow-group per direction, 253 flows per flow-group) with all packets containing Ethernet header, IPv6 header and static payload. MAC addresses are matching MAC addresses of the TG node interfaces.

  • [Ref] Applicable standard specifications: RFC2544.

 Test Name 

 Throughput: 
1. Mpps Gbps (NDR)
2. Mpps Gbps (PDR)

One-Way Latency Percentiles in uSec at %PDR load,
one set per each direction:
3. P50 P90 P99 P50 P90 P99 (10% PDR)
4. P50 P90 P99 P50 P90 P99 (50% PDR)
5. P50 P90 P99 P50 P90 P99 (90% PDR)

 78b-1t1c-ethip6-ip6base-ndrpdr 

 1.  4.38       3.44 
2. 4.49 3.52

3. 22 65 104 23 35 88
4. 40 99 109 41 101 111
5. 103 121 139 91 108 135

 78b-4t4c-ethip6-ip6base-ndrpdr 

 1.  7.73       6.06 
2. 7.73 6.06

3. 22 41 57 23 24 57
4. 30 49 61 24 36 43
5. 61 80 93 62 81 95

10ge2p1x520-ethip6-ip6scale200k-ndrpdr

RFC2544: Pkt throughput IPv6 routing test cases

  • [Top] Network Topologies: TG-DUT1-DUT2-TG 3-node circular topology with single links between nodes.

  • [Enc] Packet Encapsulations: Eth-IPv6 for IPv6 routing.

  • [Cfg] DUT configuration: DUT1 and DUT2 are configured with IPv6 routing and 2x100k static IPv6 /64 route entries. DUT1 and DUT2 tested with Intel-X520-DA2.

  • [Ver] TG verification: TG finds and reports throughput NDR (Non Drop Rate) with zero packet loss tolerance and throughput PDR (Partial Drop Rate) with non-zero packet loss tolerance (LT) expressed in percentage of packets transmitted. NDR and PDR are discovered for different Ethernet L2 frame sizes using MLRsearch library. Test packets are generated by TG on links to DUTs. TG traffic profile contains two L3 flow-groups (flow-group per direction, 100k flows per flow-group) with all packets containing Ethernet header, IPv6 header with IP and static payload. MAC addresses are matching MAC addresses of the TG node interfaces. Incrementing of IP.dst (IPv6 destination address) field is applied to both streams.

  • [Ref] Applicable standard specifications: RFC2544.

 Test Name 

 Throughput: 
1. Mpps Gbps (NDR)
2. Mpps Gbps (PDR)

One-Way Latency Percentiles in uSec at %PDR load,
one set per each direction:
3. P50 P90 P99 P50 P90 P99 (10% PDR)
4. P50 P90 P99 P50 P90 P99 (50% PDR)
5. P50 P90 P99 P50 P90 P99 (90% PDR)

 78b-1t1c- 
ethip6-ip6scale200k-ndrpdr

 1.  1.91       1.50 
2. 1.96 1.53

3. 23 69 109 23 64 110
4. 28 204 225 25 205 224
5. 162 240 258 170 237 260

 78b-2t2c- 
ethip6-ip6scale200k-ndrpdr

 1.  3.40       2.67 
2. 3.40 2.67

3. 23 66 149 23 63 144
4. 76 185 211 75 191 219
5. 181 232 279 181 238 288

 78b-4t4c- 
ethip6-ip6scale200k-ndrpdr

 1.  5.82       4.57 
2. 5.88 4.61

3. 23 95 119 24 56 98
4. 64 113 131 69 115 135
5. 115 140 179 118 145 185

10ge2p1x520-ethip6-ip6scale20k-ndrpdr

RFC2544: Pkt throughput IPv6 routing test cases

  • [Top] Network Topologies: TG-DUT1-DUT2-TG 3-node circular topology with single links between nodes.

  • [Enc] Packet Encapsulations: Eth-IPv6 for IPv6 routing.

  • [Cfg] DUT configuration: DUT1 and DUT2 are configured with IPv6 routing and 2x10k static IPv6 /64 route entries. DUT1 and DUT2 tested with Intel-X520-DA2.

  • [Ver] TG verification: TG finds and reports throughput NDR (Non Drop Rate) with zero packet loss tolerance and throughput PDR (Partial Drop Rate) with non-zero packet loss tolerance (LT) expressed in percentage of packets transmitted. NDR and PDR are discovered for different Ethernet L2 frame sizes using MLRsearch library. Test packets are generated by TG on links to DUTs. TG traffic profile contains two L3 flow-groups (flow-group per direction, 10k flows per flow-group) with all packets containing Ethernet header, IPv6 header with IP and static payload. MAC addresses are matching MAC addresses of the TG node interfaces. Incrementing of IP.dst (IPv6 destination address) field is applied to both streams.

  • [Ref] Applicable standard specifications: RFC2544.

 Test Name 

 Throughput: 
1. Mpps Gbps (NDR)
2. Mpps Gbps (PDR)

One-Way Latency Percentiles in uSec at %PDR load,
one set per each direction:
3. P50 P90 P99 P50 P90 P99 (10% PDR)
4. P50 P90 P99 P50 P90 P99 (50% PDR)
5. P50 P90 P99 P50 P90 P99 (90% PDR)

 78b-1t1c- 
ethip6-ip6scale20k-ndrpdr

 1.  2.73       2.14 
2. 2.84 2.23

3. 23 53 84 23 49 89
4. 38 129 141 43 138 150
5. 131 168 206 135 171 206

 78b-2t2c- 
ethip6-ip6scale20k-ndrpdr

 1.  4.50       3.53 
2. 4.57 3.58

3. 22 68 126 23 62 124
4. 62 148 172 60 146 164
5. 160 197 246 128 178 218

 78b-4t4c- 
ethip6-ip6scale20k-ndrpdr

 1.  6.35       4.98 
2. 6.48 5.08

3. 23 41 61 23 38 58
4. 50 92 105 49 94 107
5. 94 117 136 92 117 132

10ge2p1x520-ethip6-ip6scale2m-ndrpdr

RFC2544: Pkt throughput IPv6 routing test cases

  • [Top] Network Topologies: TG-DUT1-DUT2-TG 3-node circular topology with single links between nodes.

  • [Enc] Packet Encapsulations: Eth-IPv6 for IPv6 routing.

  • [Cfg] DUT configuration: DUT1 and DUT2 are configured with IPv6 routing and 2x1M static IPv6 /64 route entries. DUT1 and DUT2 tested with Intel-X520-DA2.

  • [Ver] TG verification: TG finds and reports throughput NDR (Non Drop Rate) with zero packet loss tolerance and throughput PDR (Partial Drop Rate) with non-zero packet loss tolerance (LT) expressed in percentage of packets transmitted. NDR and PDR are discovered for different Ethernet L2 frame sizes using MLRsearch library. Test packets are generated by TG on links to DUTs. TG traffic profile contains two L3 flow-groups (flow-group per direction, 1M flows per flow-group) with all packets containing Ethernet header, IPv6 header with IP and static payload. MAC addresses are matching MAC addresses of the TG node interfaces. Incrementing of IP.dst (IPv6 destination address) field is applied to both streams.

  • [Ref] Applicable standard specifications: RFC2544.

 Test Name 

 Throughput: 
1. Mpps Gbps (NDR)
2. Mpps Gbps (PDR)

One-Way Latency Percentiles in uSec at %PDR load,
one set per each direction:
3. P50 P90 P99 P50 P90 P99 (10% PDR)
4. P50 P90 P99 P50 P90 P99 (50% PDR)
5. P50 P90 P99 P50 P90 P99 (90% PDR)

 78b-1t1c- 
ethip6-ip6scale2m-ndrpdr

 1.  1.84       1.44 
2. 1.87 1.46

3. 23 65 104 23 33 89
4. 33 230 262 41 233 262
5. 156 250 288 168 248 284

 78b-2t2c- 
ethip6-ip6scale2m-ndrpdr

 1.  3.30       2.59 
2. 3.33 2.61

3. 23 71 109 23 58 90
4. 81 183 225 83 185 217
5. 169 233 291 178 250 608

 78b-4t4c- 
ethip6-ip6scale2m-ndrpdr

 1.  5.75       4.51 
2. 5.81 4.55

3. 23 47 73 24 28 38
4. 60 104 123 60 106 124
5. 125 152 185 132 162 205